Notification settings

Only available in: BSS and BMS

In the notification settings it is possible to set for various notifications in which case an e-mail should be sent as a result of the analyses. The different messages are described here.

Open notification settings

The screen can be opened from the ship overview screen via Edit → Notification settings.

Editing the notification settings

Depending on the fleet, the duration and percentage of the following settings can be adjusted:

Description setting	Meaning	Fleet dependent
GPS quality bad	Setting for the gps signal 'bad', i.e.: the signal is bad or absent
GPS antenna failure	Setting for an antenna error
Gps data failure	Setting for an error in the gps data
TP error	Setting for a turbo pressure error	X
TP status unknown 1	Setting 1 for unknown turbo pressure status	X
TP status unknown 2	Setting 2 for an unknown turbo pressure status	X
RPM error	Setting for a RPM error	X
Duty cycle error	Setting a duty cycle error	X
Ship state unknown 1	Setting 1 for ship status unknown
Ship state unknown 2	Setting 2 for ship status unknown
TP error while fishing/sailing	Setting for a turbo pressure error during fishing or sailing	X
RPM error while fishing/sailing	Setting for a RPM error during fishing or sailing	X
Duty cycle error while fishing/sailing	Setting for a duty cycle error during fishing or sailing	X
All analogue inputs disabled	Setting for disabled analogue inputs	X

To receive an e-mail about a report, the following information must be entered:

• Duration: the length of time in which the notification takes place.
• Percentage: the percentage of registrations in which the notification at least occurred.

After closing with OK the changes are saved and used.

After closing the screen with X or Cancel, the changes are not saved and used.

Note: A notification is sent a maximum of once a day, to avoid sending many e-mails.

Set receiver

In receiver settings you can specify who should receive the e-mails.